The Analysis of Working Possibilities of a Power Shovel
The calculation of the forces acting on the bucket during the excavation process is described in the paper. The knowledge of these forces is needed for the automation of the shovel. These forces are calculated by a computer controlling the due work of the equipment and the hydraulic feeder system. The procedure of calculation of the maximum forces acting on the excavated ground is described as well.
G. DAHLQUIST and A. BJORCK, Numerical method [in Polish], PWN, Warszawa 1983.
W. GIERULSKI and Z. SENDER, Structure analysis and linearization of the vibration model of a single-bucket excavator [in Polish], Enging. Trans., 38, 3, 1990.
W. GIERULSKI, L.PŁONECKI et al., Elements of the computer model of a microprocessor excavator control system [in Polish], IFTR Reports, 44, 1988.
W. GIERULSKI, L.PŁONECKI et al.1 Computer simulation of the power shovel and its fitting digital control [in Polish], IFTR Reports, 9, 1991.
W. GIERULSKI and S. WÓJCIK, Equation solution procedure of a mathematical model in computer-aided simulation process [in Polish], Sterowanie i Napęd Hydrauliczny, 1, 1992.
R. GUTOWSKI, Analytical mechanics [in Polish], PWN, 1971.
A. PIZOŃ, Hydraulic and electrohydraulic control systems [in Polish], WNT, 1987.
L. PŁONECKI and J. CENDROWICZ, Digital controlled hydraulic drives of working machines, Enging. Trans., 41, 3-4, 1993.
Copyright © 2014 by Institute of Fundamental Technological Research
Polish Academy of Sciences, Warsaw, Poland